Raymarine forum / Raymarine Forums / Multifunction Displays v / [CA] [CA11] Continuing problems with Axiom Fuel Manager

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Continuing problems with Axiom Fuel Manager
10-10-19, 11:31 AM (This post was last modified: 10-10-19 12:49 PM by Chuck - Raymarine - Moderator.)
Post: #9
jfitch Offline
Junior Member
**
 		Posts: 25
Joined: Jul 2018
Reputation: 0
RE: [CA11] Continuing problems with Axiom Fuel Manager
The i70s correctly displays the engine hours, always. The Axiom is misinterpreting both hours and fuel. Since it gets only fuel/hour data from the interface, a mistake in hours probably would result in a mistake in fuel. It should be proportional though, and it is not - so it must be mistaking fuel use as well.

The GPS source is set to the Vesper XB8000.

I'll try to get the logs - if I recall it will only write these logs to the SD card installed in the back? That has the Navionics charts and I'd hate to have them corrupted. Also, on any Axiom installed in a panel, access to that card is poor. Is there a way to change where it writes these files to the external SD or USB card?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] Continuing problems with Axiom Fuel Manager - jfitch - 10-10-19 11:31 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication