[LW11] Pump position

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[LW] [LW11] Pump position

10-10-19, 01:03 PM (This post was last modified: 10-22-19 08:32 AM by Derek - Raymarine - Moderator.)

Post: #3

engenharia2 Offline

Junior Member

Posts: 31
Joined: Jul 2016
Reputation: 0

RE: [LW11] Pump position

Derek

thank you for the answer, but unfortunately the cubic capacity will be about 1500 cc, before I receive this information I was thinking about in ACU 300 with constant running but this pump is 1200cc. Do you know any solution for this? Attached is the specification about the surface drive used on this boat, for better undertand.

Thank in advance

Attached File(s)
.pdf

Surface drive.pdf (Size: 416.74 KB / Downloads: 334)

« Next Oldest | Next Newest »

Messages In This Thread

[LW11] Pump position - engenharia2 - 10-04-19, 01:14 PM

RE: [LW11] Pump position - Derek - Raymarine - Moderator - 10-08-19, 08:43 AM

RE: [LW11] Pump position - engenharia2 - 10-10-19 01:03 PM

RE: [LW11] Pump position - Derek - Raymarine - Moderator - 10-22-19, 09:05 AM

User(s) browsing this thread: 1 Guest(s)