[CA] [CA11] NMEA logs-can't select SD2

[BernieK]

On the problems with fuel manager thread I was asked to supply logs.
However, when I select MEA 2000 log
OME->SET-UP->NETWORK->DIAGNOSTICS->NMEA DEVICES & MESSAGES->NMEA MESSAGES->RECORD->START RECORDING / STOP RECORDING
there is a setting to select SD1 or 2. I selected SD2 and did a recording but it saved to SD1 (my Navionics card).
When I checked even though I selected SD2 it reverted to SD1.

Also when I updated to 3.10.71 via WIFI, I first saved all my data to SD2.
It was not there after the upgrade and in fact SD2 had a cross linked file which caused LH3 to lockup with the little circle indicator running when I tried to restore the data. No controls would work.
(I fixed it with my PC, I lost the backup but luckily had an older backup so I didn't lose much)

I did eject both SD1 & SD2 and powered off the display, removed both cards & did the upgrade, did a factory reset, cycled the power replaced the cards and tried to restore the data and that is when LH3 locked up. I let it run for a couple of hours in case it was doing some data manipulation then power cycled it.

So far the Navionics card still works. I have now installed it in SD2.

I have a Axiom Pro 16