Raymarine forum / Raymarine Forums / Multifunction Displays v / [TG] [TG11] ECI100 bidirectional?

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] [TG11] ECI100 bidirectional?
10-29-19, 12:25 AM
Post: #10
Tom - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 1,067
Joined: Nov 2017
Reputation: 7
RE: [TG11] ECI100 bidirectional?
Hi, sorry for the delay replying.

There are two ways to connect Yamaha engines and Axiom MFDs: the ECI100 or a Yamaha gateway (either CL7 display or part 6YG-8A2D-00-00.) The former gives you standard NMEA2000 engine data and steer-by-wire pilot control (if you have an EV2-DBW pilot and Helm Master electronic steering), the latter gives you standard engine data and the Yamaha app. Since you're not interested in the Yamaha app and have ECI100, in your case you would select 'Other' (generic NMEA2000) engine type, and then run the engine setup wizard.

You are quite right that the ECI's guide is outdated, and in this case the Axiom's LH3 advanced operation guide is the better reference.

Regards,
Tom
Raymarine since 1999.
Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras
Location: Sydney, Australia.

Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[TG11] ECI100 bidirectional? - BernieK - 08-09-19, 08:06 PM
RE: [TG11] ECI100 bidirectional? - Tom - Raymarine - Moderator - 10-29-19 12:25 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication