[CA11] es78 Lighthouse II settings - Temperature Off-Set, Heading & Heading Line

[JeepSWAG]

Thanks Chuck,

I tried to enable the vector;

1.SelectPresentation.
2.SelectVectors.
3.Select HeadingVector >Enable

After I made the change and pressed X to exit the setup screen the heading vector does not show. When I go back into the setup screen the setting is set back to disabled. I have not set the heading vector length and width. Do these need to be set in order for the heading vector to remain enabled?

Again, I've tried to adjust the temperature off-set. When I do, nothing seems to change. I make the adjustment in the settings screen, press the X in the settings screen in order to exit to the home page. When I go back in the settings screen, the offset is still set. Temp in the data bar does not change. I have tried this with the maximus setting of 9.9 degrees with not change.

I understand the North Up issue. Thanks for pointing me in the right direction (get it?)