[LW] [LW11] I70s and ITC-5 wind problem

[fozzy83]

Hi Louise

Thanks for your reply

I’m not sure what software I’m running on the itc-5. It was fitted straight from the box to the existing network.

I have a system consisting of a C90W plotter, p70 head and A300 autopilot, digital yacht AIS unit all on the network which I then added the I70s system pack. This consists of the i70s head, wind transducer and tri-data depth transducer. Only wind and depth units are connected to the itc-5 unit.

Speed has not worked yet despite checking connections numerous times and confirming open/closing circuit from the unit when turning the paddle wheel.

Wind and direction and strength was working until this fault. I have completed all the tests however with the red and screen disconnected from the wind connections I get a steady connected light and 8v on the red terminal. When I reconnect and power up the flashing light returns on the wind set of terminals and I can only read 1-2 volts.

Thanks