[CA] [CA11] RV-100 Transducer Placement

[DFMott]

Obviously not the answer I wanted to hear but thank you.

You said "the low vertical height on the step (insufficient to properly mount a transom mounted transducer)" I believe I have 4"+ there. Wouldn't that be enough space to mount the transducer in position A on my diagram? And if so would that work if it were positioned close to the keel?

Installing a pair of thru the hull transducers presents issues as well because the fuel tank sits just behind where the B163 is mounted and i am not sure there is enough room for the RV3XX...

Q1 If there is room how close can it be to the B163 and the rear of the hull (Where the step begins)?

Q2 Are there any benefits to the stainless or bronx over the plastic for a boat that sits in salt water 24/7?


Thank you for your help.