The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / General Discussions v / [CA] [CA11] RV100 and RV200 install on stepped hull

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] RV100 and RV200 install on stepped hull
12-19-19, 12:36 PM (This post was last modified: 12-19-19 02:25 PM by Chuck - Raymarine - Moderator.)
Post: #1
Sund3638 Offline
Junior Member
**
 		Posts: 2
Joined: Dec 2019
Reputation: 0
[CA11] RV100 and RV200 install on stepped hull
I have a 1996 Grady White Chase that has a stepped hull (1) and would lie to know if the RV100 transom mount transducer can be installed on the first step where it will be completely submerged. Raymarine also has a bracket for stepped hulls so will this be needed and if so, how does it install?

My boat also has 2 built in transducer platforms under the hull for 0 degree thru hull installs on both sides of keel about 1.5' from the keel. Can the RV200 0 degree be installed as a pair because it was designed for a single flat keel install or are the only pairs that can be installed on a boat are the angled RV200's, which I cannot use?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] RV100 and RV200 install on stepped hull - Sund3638 - 12-19-19 12:36 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication