[CA11] drive clutch not engaging

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[CA] [CA11] drive clutch not engaging

12-28-19, 02:59 PM (This post was last modified: 12-30-19 02:23 PM by Chuck - Raymarine - Moderator.)

Post: #1

[email protected] Offline

Junior Member

Posts: 3
Joined: Dec 2019
Reputation: 0

[CA11] drive clutch not engaging

Installing Evolution Autopilot (ACU-200), and going through the setup, the drive clutch doesn't even try to engage. I can externally engage the clutch, and the helm will move.

Have I missed a setting of some sort?

Drive unit is from my previous autopilot (Cetek-Benmar model "M")

On Edit:
When I put the A/P in "auto", the voltage to the clutch is 0.054V. If I disconnect the clutch and measure the output, it's 13.8v. It appears that the clutch is loading down the system. Would a relay be the solution?

« Next Oldest | Next Newest »

Messages In This Thread

[CA11] drive clutch not engaging - [email protected] - 12-28-19 02:59 PM

RE: [CA11] drive clutch not engaging - Chuck - Raymarine - Moderator - 12-31-19, 10:34 AM

RE: [CA11] drive clutch not engaging - [email protected] - 12-31-19, 06:41 PM

RE: [CA11] drive clutch not engaging - Chuck - Raymarine - Moderator - 01-02-20, 10:04 AM

User(s) browsing this thread: 1 Guest(s)