[CA11] drive clutch not engaging

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[CA] [CA11] drive clutch not engaging

12-31-19, 06:41 PM (This post was last modified: 01-02-20 12:52 PM by [email protected].)

Post: #3

[email protected] Offline

Junior Member

Posts: 3
Joined: Dec 2019
Reputation: 0

RE: [CA11] drive clutch not engaging

Upon further testing, I determined that the clutch solenoid measured 1 ohm, but when I activate it, it draws only 1.06 amps. The ACU-200 is supposed to sink 2 amps, so this is somewhat confusing.
Nevertheless, a simple headlight relay seems to have solved the problem.
Hard-over time is somewhere around 20 seconds.
Boat is an O'day 37 (disp. 7 tons).
Rudder reference is not installed.
Have not done sea test yet. . .dockside only.
Type I rotary drive.

« Next Oldest | Next Newest »

Messages In This Thread

[CA11] drive clutch not engaging - [email protected] - 12-28-19, 02:59 PM

RE: [CA11] drive clutch not engaging - Chuck - Raymarine - Moderator - 12-31-19, 10:34 AM

RE: [CA11] drive clutch not engaging - [email protected] - 12-31-19 06:41 PM

RE: [CA11] drive clutch not engaging - Chuck - Raymarine - Moderator - 01-02-20, 10:04 AM

User(s) browsing this thread: 1 Guest(s)