The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Instruments v / [TG] [TG11] Depth Overlay Not Displaying

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] [TG11] Depth Overlay Not Displaying
12-31-19, 11:56 PM (This post was last modified: 01-14-20 08:36 PM by Chuck - Raymarine - Moderator.)
Post: #1
Life Uncharted Offline
Junior Member
**
 		Posts: 2
Joined: Dec 2019
Reputation: 0
[TG11] Depth Overlay Not Displaying
I had two Axiom MFDs, 4 i70's and 2 i60s all working fine. I had the depth overlay on the chart display. I replaced the i60s with i70s and installed an ITC-5 to connect the wind, speed and depth to the network. I am running LightHouse version 3.7.7.

Since installing the ITC-5 the depth overlay display on the chart is not displaying any value. I just get blanks ( -.- ) . The depth displays correctly on the i70s so I believe the wiring to the ITC-5 is correct. The only place the depth is not properly displaying is the MFD chart overlay (neither MFD overlay display is working). I deleted and re-added the depth overlay but that did not resolve the issue.

Any suggestions?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[TG11] Depth Overlay Not Displaying - Life Uncharted - 12-31-19 11:56 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication