[CA] [CA11] EV-150 without control head

[Chuck - Raymarine - Moderator]

Welcome to the Raymarine Forum Balao71,

Controlling and setting up an Evolution autopilot via a MFD running LightHouse 3 software is achieved as follows:
- Enable Pilot Control (HOME->SETTINGS->AUTOPILOT->PILOT CONTROL->ON)
- Verify that the autopilot's EV-1 and ACU have each been updated with the latest available Raymarine product software update and if not, update the software within these products accordingly. The currently installed software may be determined by examining the MFD's Product Info diagnostic dialog (HOME->SETTINGS->NETWORK). If the software within either of these components is updated, then a Pilot Factory Reset ( must be performed.
- Configure Pilot Set-up Hull Type, Drive Type, and Speed Input configuration settings (HOME->SETTINGS->AUTOPILOT->PILOT SET-UP)
- See the aforementioned FAQ providing the command sequence to execute the Dockside Wizard
- Please click here to view the FAQ addressing the short cruise to be undertaken to determine the magnetic deviation sensed by the EV-1 CCU.