[CA] [CA11] UAV application with Axiom XL

[Chuck - Raymarine - Moderator]

Welcome to the Raymarine Mig888,

Q1. I must first detach the external card reader to attach the USB cable running from the UAV's controller to the Axiom XL.
Q1. Alternatively, the chart card may be moved to the MFD's memory card reader or that of an interfaced MFD's memory card reader (i.e. remove the microSD chart card from it SD adapter sleeve and insert it into the MFD's microSD memory card slot.

Q2. This is fine, but clearly I will not be able to use my Navionics chart simultaneously with the UAV.
A2. N/A ... see response to Q1.

Q3. Is there some sort of "splitter" I can buy so that the card reader can be simultaneously connected with the UAV controller to the Axiom XL?
A3. Negative.

Q4. Even if there is a splitter, would the Axiom XL be able to handle both the card reader and the UAV controller at the same time?
Q4. N/A.

Q5. I assume it can utilize the preloaded system maps even if the Navionics maps cannot be used.
A5. See my response to Q1. When interfaced to one another via Ethernet networking (RayNet / SeaTalkhs) cartography, as well as all other system resources and data are shared among the system's MFDs. While the Axiom UAV feature may only be exercised on the MFD which has been connected to the UAV's remote control, cartography from chart cards within the readers (or remote card readers) of the system's MFDs will be available to all MFDs within the system.

Q6. I have two Axiom XL MFDs. Both have external card readers. Is it possible to run the Navionics through one of the Axiom XL readers and the UAV through the other so that the Navionics will appear on the same screen as the UAV?
A6. Yes. See the responses to Q1 & Q5.