[CA] [CA11] I50 Depth and Fish Finder

[[email protected]]

Hi Check,

My apologies for the confusion.

New boat had ST60 wind and ST4000 Autohelm (connected to compass device).

I have I60 wind (and transducer) I50 depth and I50 speed (and impeller) from old boat.

I am attempting to integrate my "I" instruments with "ST" instruments and add the Element and integrating everything, including fish finder capabilities, as much as reasonably possible.

I have attached an updated diagram based on your suggestions....

1. I have replaced ST60 wind with I60 wind
2. I have added power supply so power now runs to 5 way connector in addition to the Element
3. I have added Actisense converter to interface with ST4000 Autohelm with 5 way connector
4. I have added terminator plugs at either end of the 5 way connectors

Provided that this latest diagram checks out my only remaining question (famous last words) is will the original wind vane / transducer that comes with the original ST60 wind instrument work with the newer I60 wind instrument. I have the vane / transducer for I60 but may not be able to get up the mast to replace just yet. I am hoping the original cable will work.

Hopefully I can leave you in peace after this thanks so much for all your help!

Regards,

Andrew