[CA11] i40 BiData depth

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[CA] [CA11] i40 BiData depth

01-19-20, 06:26 PM (This post was last modified: 01-22-20 10:00 AM by Chuck - Raymarine - Moderator.)

Post: #1

jpmesa Offline

Junior Member

Posts: 1
Joined: Apr 2018
Reputation: 0

[CA11] i40 BiData depth

My newer 140 Depth signal keep counting down from normal depth to 00 after a few minutes and stays at 00. Today my speed also says 00. The both use to work fine. Is it a seatalk problem? The i40 is using my old autohelm Depth & speed transducer. The old autohelm with seatalk work fine but the old screen was badly cracked. The on & off switch on the board is fine. Any ideas? Thanks
PS Trying to see if there are any old wire connections in the lines that might be shorting...

« Next Oldest | Next Newest »

Messages In This Thread

[CA11] i40 BiData depth - jpmesa - 01-19-20 06:26 PM

RE: [CA11] i40 BiData depth - Chuck - Raymarine - Moderator - 01-22-20, 10:08 AM

User(s) browsing this thread: 3 Guest(s)