[CA11] Proper Autopilot Package for Replacing Simrad

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[CA] [CA11] Proper Autopilot Package for Replacing Simrad

01-21-20, 07:05 AM (This post was last modified: 01-21-20 09:23 AM by Chuck - Raymarine - Moderator.)

Post: #3

gdssoftware Offline

Junior Member

Posts: 3
Joined: Feb 2016
Reputation: 0

RE: [CA11] Proper Autopilot Package for Replacing Simrad

Chuck, finally found the correct specs for the Simrad ram/pump

1.Pump Unit is RPU80 12 V J3000X/AC10 80
2. Capacity Min (4,9 cu in) Max (15.2 cu in)
3. Peak Flow: Peak flow 49 cu in/min
4. Max Pres:60 bar (870 psi)
5. Max Current:6 Amp

Would like to replace the Simrad electronics with RayMarine and keep the pump/actuator.

Any advice is appreciated.

Thanks,

Ned Bennett

« Next Oldest | Next Newest »

Messages In This Thread

[CA11] Proper Autopilot Package for Replacing Simrad - gdssoftware - 02-03-17, 10:02 AM

RE: [CA11] Proper Autopilot Package for Replacing Simrad - Chuck - Raymarine - Moderator - 02-03-17, 02:41 PM

RE: [CA11] Proper Autopilot Package for Replacing Simrad - Chuck - Raymarine - Moderator - 01-21-20, 10:46 AM

RE: [CA11] Proper Autopilot Package for Replacing Simrad - gdssoftware - 01-21-20, 09:38 PM

RE: [CA11] Proper Autopilot Package for Replacing Simrad - Chuck - Raymarine - Moderator - 01-22-20, 08:08 AM

User(s) browsing this thread: 1 Guest(s)