[TG] [TG11] Axiom pro rvx transducer

[Mleads310]

If I may jump in here to help as I've just gone through something very similar. I currently have a Grady white sailfish 282. The transducer flat is not big enough for most transducers, Let alone a transducer with a fairing block. I currently had a b744 in that location with no fairing block which was reading great at any speed. I upgraded to axiom pro RVX and wanted a transducer with chirp, that was compatible with the axiom pro RVX and that would fit into the same spot.

The best choice was the b765. Which comes in either high/low or medium only chirp.
The reasons why I chose this transducer of the following:
-The B744 shares the same diameter whole size as the b765
-I've had great results on that transducer flat with no fairing block which means I would have to put a direct size replacement in that spot which the b765 is.
-Even though it is only a two element chirp transducer, it is still chirp and it is still compatible with axiom pro rvx.

Hope this helps is this directly applies to your situation. If you are looking to proceed with a larger size transducer you would end up having to remove one of your pickup inlets either on the port or starboard side closer to the keel in order to fit for its location. The reason why I know this is because I'm going to remove one of my pickups next year to make room for a pair of RV-220 transducers.