[LW11] ST 5000+

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[LW] [LW11] ST 5000+

01-21-20, 09:56 PM

Post: #2

Tom - Raymarine - Moderator Offline

Administrator

Posts: 1,067
Joined: Nov 2017
Reputation: 7

RE: [TG11] ST 5000+

Hello Neil,

We haven't had any spares for ST4000+ displays for some years, they were retired a long time ago. And attempting component-level repairs on modern surface-mount PCBs tends not to be either economic in labour time or very reliable.

Yes, you can use an ST5000+, it's actually the same circuit board. Just go into the dealer calibration and set the Drive type correctly ('4000 WHL') and do the rest of the calibration as for a new installation.

Regards,
Tom

Raymarine since 1999.
Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras
Location: Sydney, Australia.

Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests.

« Next Oldest | Next Newest »

Messages In This Thread

[LW11] ST 5000+ - NeilK - 01-20-20, 02:30 PM

RE: [TG11] ST 5000+ - Tom - Raymarine - Moderator - 01-21-20 09:56 PM

RE: [LW11] ST 5000+ - NeilK - 01-22-20, 06:14 AM

User(s) browsing this thread: 1 Guest(s)