[CA] [CA11] Comnav 1001 & Axiom Autoroute

[Chuck - Raymarine - Moderator]

Welcome to the Raymarine Forum

Should the Comnav 1001 AP support NMEA 0183 v2.0 or higher communications, then a NMEA 0183 to NMEA 2000 data bridging device (ex. Actisense NGW-1-STNG, etc.) may be used to interface to autopilot to a spur socket within the backbone. Should navigation (Go To Cursor/Waypoint or Follow Route) be commanded by the MFD, then the associated data will bye transmitted by the MFD to the powered and properly terminated SeaTalkng / NMEA 2000 backbone and then passed to the third party autopilot via the NMEA 0183 to NMEA 2000 data bridging device. The autopilot's control head may then be used to command the autopilot into track mode (i.e. the mode by which an autopilot steers to a location rather than to a locked heading).