[LW] [LW11] acu200 +EV1 and st6002 compatibility???

[Louise - Raymarine - Moderator]

Dear getaway.

Thank you for your post.

You can use the ST6002 installation manual to perform the calibration. The docuemnt is 'Smart Pilot install & commissioning with ST6001, ST6002, ST7001, ST7002, ST8001, ST8002 controllers' - this can be found under legacy pilot manuals>pilot control here.

The limitations are as follows;
-Compass reset, Diagnostics & Patterns not available!
-Hard over time for RRT-less operation not available!
-Dockside commissioning not available!
-Drive and Rudder Offset have to be set manually!
Some functions are different:
-Response – (1-2-3)
-Vessel type – (Semi-Disp.-Planing-Workboat-Sail)
-Drive Type (3-4)

How have you connected the ST1 to STng convertor? Is the backbone correctly terminated?

Are you getting wind data on any of the other products?

Many Thanks
Louise