Threaded Mode | Linear Mode

Tamaroak14 · 02-26-16, 02:33 PM

[quote='Steve - Raymarine - Moderator' pid='368' dateline='1456496144']
The fluxgate compass that works with the S1 Smartpilot, is part number M81190.
To remove the wires from the S1 course computer, you will be pushing in on the T's at the top of the terminal strip. The T is designed to accept a jewel flat screw driver head, push in to release.

I push in the little plastic thingies and nothing happened. I tried to make them go in in the sections just to the right of the compass where there are no wires, and nothing happened. Maybe pry up or down? It does seem to fit the screwdriver. It doesn't go in any farther. I'm afraid to get these wires out and not be able to get them back in again. This doesn't seem like a very good system
And I'm in the Bahamas, no one to get help from that speaks Raymarine.