European Union (.eu)
United States (.com)
United Kingdom (.co.uk)
Australia (.com.au)
Denmark (.dk)
Finland (.fi)
France (.fr)
Germany (.de)
Italy (.it)
Norway (.no)
Netherlands (.nl)
Spain (.es)
Sweden (.se)
Search
Member List
Calendar
Help
Raymarine forum
/
Raymarine Forums
/
Product Selection Assistance 
/
[DG] [DG11] St60 wind transducer not working
/
[DG] [DG11] St60 wind transducer not working
|
[DG] [DG11] St60 wind transducer not working
|
|
02-25-20, 01:12 AM
Post: #2
|
|||
|
|||
|
RE: [TG11] St60 wind transducer not working
Hello Nick,
I would guess that you may have moisture in the masthead connector. Looking at a windvane here, I measure the following approximate resistances on the display end of the windvane cable when disconnected from the display: Red-shield: ~24kOhms Red-green and Red-blue: ~75kOhms Red-yellow: ~90kOhms Higher resistances than these would indicate something like a chafed cable, but lower resistances (and particularly changing resistances) would be a fair pointer towards water ingress. Regards, Tom Raymarine since 1999. Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras Location: Sydney, Australia. Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests. |
|||
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
[DG11] St60 wind transducer not working - [email protected] - 02-19-20, 02:57 PM
RE: [TG11] St60 wind transducer not working - Tom - Raymarine - Moderator - 02-25-20 01:12 AM
|
User(s) browsing this thread: 1 Guest(s)