Raymarine forum / Raymarine Forums / Autopilots v / [CA] [CA11] Upgraded autopilot. No dockside wizard.

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Upgraded autopilot. No dockside wizard.
02-26-20, 03:58 AM
Post: #5
Bfb1115 Offline
Junior Member
**
 		Posts: 10
Joined: May 2019
Reputation: 0
RE: [CA11] Upgraded autopilot. No dockside wizard.
Hi Chuck,

Was able to update the E80 MFD, but the EV1, ACU, P70 etc were not detected, so I was not able to update them from the MFD. Sounds like some sort of interface/connection issue. My devices are connected as follows (I believe, since I can't open the navpod without a special head). P70s connected via seatalkNG to Seatalk 2 cable, connected to a seatalk coupler panel, connected to a seatalk 2 cable that is then daisy chained to all the ST60 devices. Seatalk 2 cable backbone to a spliced on seatalkng cable to the seatalkNG converter. Converter branches to EV1, and to the ACU 400.

I'm realizing this is probably not optimal. So what is the best way to connect the system with old ST60 devices that still have the seatalk2 adapter on the cables?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] Upgraded autopilot. No dockside wizard. - Bfb1115 - 02-26-20 03:58 AM

Forum Jump:


User(s) browsing this thread: 3 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication