[TG] [TG11] MFD Lockup-alarm active

[BernieK]

Something to add that i just found.

I made a new route to a new fishing spot.
It started just past an old route.
The new route worked perfectly.
I did not on this occasion follow the old route but close to the end of that route, I followed the new route.
On this new route, the MFD DID NOT give a waypoint alarm alarm like the old route. The P70r asked for turn permission at each waypoint as usual.

Unfortunately, when i got home I modified this new route by adding the waypoints in the old route to the start of new route.

I backed up the routes and used a text editor to see if there were any differences. There are in fact differences

I copied the relevant sections of the GPX file of the route to a text file called RouteDifference.txt which I have attached. (hey, I don't have a life!)

It contains the last waypoint (out6) of the old route and the first waypoint ( waypoint26) of the new.

The definition of waypoint26 contains 2 extra lines

<raymarine:GroupGUID>d58b-3d18-0001-510e</raymarine:GroupGUID>
<raymarine:GroupName>Al</raymarine:GroupName>

and the time portion of out6 is set to T00:00:00Z

The old route was created on my old boat using lighthouse2 (E125).

I have also attached the full route file.
The route called OUTWARD is the old route created with lighthouse 2
The other routes have (usually) been created by adding the outward route waypoints to new routes.
The new route is called "Deep Drop Moreton 350m"