[DG] [DG11]Seatalk Failure

[Derek - Raymarine - Moderator]

Hi Michael,

Thank you for your enquiry,

SeaTalk failure on the Autopilot control unit indicates that there is some corruption or faulty product on the network, that is affecting the network communications. If you disconnect the wind does the system start to work again, ( note you should power cycle the system once the wind is unplugged), if the system still does not work, then unplug the depth display from the network, if the system still indicates SeaTalk Fail, then disconnect both the SeaTalk cables connected to the Autopilot and connect the autopilot control unit directly to one of these seaTalk connections using a short piece of SeaTalk cable. If the fault remains, then the control unit and course computer should be sent to the nearest Raymarine service dealer for investigation.

Additional diagnostics can be found here

Regards
Derek