The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Networking / System Integration v / [DG] [DG11] Seatalk - Simrad IS15

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[DG] [DG11] Seatalk - Simrad IS15
03-24-20, 08:15 AM (This post was last modified: 03-24-20 02:41 PM by Chuck - Raymarine - Moderator.)
Post: #1
NeilK Offline
Junior Member
**
 		Posts: 3
Joined: Jan 2020
Reputation: 0
[DG11] Seatalk - Simrad IS15
Hi . I hope someone can help me. I have a a Hanse yacht (2003) with all Raymarine instruments (st60wind, multi and 4000+ auto helm) and C80 chart plotter. Also have Raymarine DSM250 connected to the C80. The speed and depth transducers are connected to a Simrad IS15 transceiver. I think the Hanse was standard with Simrad equipment and the Raymarine was an option. My speed and Depth reading is gone and the transducer is fine. I’m not sure if there is an issue with the Is15 unit. I’m trying to figure out where the Roblink output cable from the IS15 goes ( how does it interfaces with Seatalk). It disappears behind a panel at the chart table close to the chart plotter. Any help would be appreciated. Thanks.
Regards Neil
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[DG11] Seatalk - Simrad IS15 - NeilK - 03-24-20 08:15 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication