Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Linear rudder reference transducer setup
03-27-20, 03:02 PM (This post was last modified: 03-27-20 05:45 PM by Chuck - Raymarine - Moderator.)
Post: #5
RE: [CA11] Linear rudder reference transducer setup
Hi Chuck,

I've reversed the wiring as you suggested, with no success. I've also reset the autopilot to factory settings and went through the setup procedure several times, with the wires arranged in both configurations. I've also updated all of the software for the heading indicator, ACU and P70. No luck. I've also checked the installation of the Seastar rudder transducer and it's right.

The one thing I've not been able to do is use the Reverse Rudder Ref as you suggest. I go through the menu, however under Drive Settings, I do not see Reverse Rudder Ref
Currently I see under Drive Settings:
Power Steer
Rudder Offset
Rudder Limit
Any thoughts?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] Linear rudder reference transducer setup - bellinghamangler - 03-27-20 03:02 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)