[CA] [CA11] e95 MFD Freezes and Continuously Reboots

[Hello Below]

My e95 MFD has provided yeoman service since new in 2014. My normal routine is to install my Navionics Platinium+ chart card in microSD1 and my data card in mircoSD2 with the power off. I then power up the MFD via the circuit breaker. In the past this has always resulted in a normal startup and allows the full functionality of the MFD. Starting this season, the e95 freezes at startup and does not respond to any soft key or hard button commands. After power is applied it skips through the legal page and seems to freeze when loading the chart card information (the little yellow timer stops at about 1/4 of the clock). After about 20-30 secs the MFD reboots itself and this cycle continues. The odd thing about this is that it only happens if I use my Platinum+ (2019) card and insert it in microSD1 and a data card is in slot 2. Any other combination results in a normal startup. Example achieving normal startup is:

- - Platinum+ (2019) in slot 1 with slot 2 empty. Once normal startup has been achieved, I can then insert the data card into slot 2 and everything is fine.
- Platinum+ (2019) in slot 2 and data card in slot 1.
- data card in slot 1 and slot 2 empty. Once normal startup has been achieved, I can then insert the Platinum+ (2019) into slot 2 and everything is fine
- both slot 1 and 2 empty. Once normal startup has been achieved, I can then insert the Platinum+ (2019) into slot 1 and the data card into slot 2 and everything is fine


What is very interesting is that if I use an older Platinum+ card (2014) I get a normal startup even with the Platinum+ (2014) card in slot 1 and the data card in slot 2 at power up.
.
I have done a factory reset and tested each microSD slot using Chuck's forum procedure. I have also tried different data SD cards from various manufacturers and various capacities. But the MFD continues to freeze and reboot with the Platinum+ (2019) in slot 1 and data card in slot 2.