[CA] [CA11] Axiom pro/rv312

[Chuck - Raymarine - Moderator]

Jarmstrong,

The Water (Temperature) data overlay has been properly configured as shown within your image. The system need only be interfaced to the RV312 transducer to then permit the Water (Temperature) data item to be populated. As far as plotting a bottom is concerned, it would not be recommended that the 3D sonar channel be used until the boat is in 10-15 feet of water having some structure which may in turn be used to practice with the RealVision channel. Within depths below this, the DownVision or Sonar channel should be relied upon to determine water depth. Should these channels have been used and the water depth have been greater than 3' beneath the transducer, then the may be something wrong with the transducers, the transducer cables, or the MFD itself. To rule out the possibility of another device with the system may be responsible for , please indicate the makes and models of any other devices which the Axiom Pro MFD has been interfaced to ... including other transducers.