Raymarine forum / Raymarine Forums / Networking / System Integration v / [CA] [CA11] Integrating Axiom 9 with ST60 and GX1400

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Integrating Axiom 9 with ST60 and GX1400
04-16-20, 08:50 AM (This post was last modified: 04-16-20 09:06 AM by Chuck - Raymarine - Moderator.)
Post: #3
aneckar1 Offline
Junior Member
**
 		Posts: 3
Joined: Apr 2020
Reputation: 0
RE: [CA11] Integrating Axiom 9 with ST60 and GX1400
Thanks Chuck for the sanity check! Since only one of the converters needs to be powered could I simplify this setup by removing the VHF to STng converter and keeping the VHF converter cable but run two backbone cables from the ST1 to STng hub to T-connectors, one with the VHF to STng adapter running to the T and the other with the DeviceNet to STng running to the NMEA gateway? Or must the VHF converter cable connect to the yellow port on the converter? Reason I ask is the spur and converter cable ends look the same. Updated diagram attached to show what I'm trying to ask.


Attached File(s) Thumbnail(s)
   
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] Integrating Axiom 9 with ST60 and GX1400 - aneckar1 - 04-16-20 08:50 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication