[CC11] reconnecting wires to M81188 rudder position sensor please

[mramsbey]

I became a co-owner on a tiller sailboat.
The drive and M81188 rudder position sensor were not attached to the mounting and bouncing around so the cable tore off the rudder position sensor. Inside is a Vishay “board” with schematic of a variable resistor and 3 terminals. I believe “blue” wire goes to #2 (center tap) and “red” and “green” go to #1 and #3 (ends). Which goes on which end?

I guess if I get it wrong I can reverse at the course computer but prefer to keep the current calibration.

Thanks!
Mark