[DG] [DG11]Seatalk Failure

[Derek - Raymarine - Moderator]

Hi [email protected]

Thankyou for the feedback.

So just to confirm, with only the control head connected via SeaTalk to the autopilot course computer, the control head and the Autopilot operate correctly - yes?

This being the case, there is likely a cable of connector problem in the system which is triggering the SEATALK FAILURE.

At this stage leave the Control head connected to the Autopilot and one by one connect the SEATALK network cable to the control unit, as soon as the failed cable is connected the alarm will be seen, unplug the affected cable and the alarm will disappear.

You will have to methodically go through the network cable by cable until you trace the root cause. It should not take too long through if you separate the network into half and then quarters.

Regards

Derek