[CC11] I70 ITc-5 no speed, temp

[Chris - Raymarine - Moderator]

Hello TuSan and welcome to the Raymarine forum,

Be advised the speed transducer does need to spin and register for a short time for the ITC-5 to "see it". Until this happens it appears the speed is not working.

Additionally we could be looking at a transducer issue.

Does the i70 show the temp?

Please see the test for the speed transducer below,
Testing the Speed Sensor:

Verify that the transducers paddle wheel is free of marine growth and rotates freely on its shaft-disregard this as it is new.
Power down the instrument
Disconnect the GREEN and SHIELD transducer leads from the instrument display or instrument pod.
Connect a multimeter to the GREEN and SHIELD transducer leads and configure the multimeter to measure continuity or resistance.
Slowly rotate the transducer paddle wheel by hand. Note that as the paddlewheel is rotated, the multimeter should alternate between an open circuit and a closed circuit with each quarter turn. As such one complete revolution of the paddle wheel should open and close the circuit four times.

Should the multimeter respond as indicated above, then the speed sensor element of the transducer would be deemed functional. If not, then the transducer has failed and should be replaced.