Raymarine forum / Raymarine Forums / Autopilots v / No Track with Garmin MFD after Updating Evolution AP

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
No Track with Garmin MFD after Updating Evolution AP
06-29-16, 01:26 PM
Post: #4
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: No Track with Garmin MFD after Updating Evolution AP
John,

Given the reported symptom, it is recommended that you examine the autopilot's diagnostics to verify that all of the autopilot components have been properly updated. These include:
EV-1/2 Sensor Core: v2.17
p70/p70R: v3.06
ACU100/ACU200/ACU300/ACU400: v2.17

If so, then it would be recommended that a log be generated from traffic on the SeaTalkng/NMEA 2000 backbone when following a route and arriving at a waypoint. If supplied with the SeaTalkng/NMEA 2000 log, a problem report may be generated to seek correction of the problem. Should you not have a Raymarine MFD, a Certified Raymarine Installer may be contacted to generate a log for you. Please additionally indicate whether this symptom was introduced with the latest Evolution autopilot software update.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: No Track with Garmin MFD after Updating Evolution AP - Chuck - Raymarine - Moderator - 06-29-16 01:26 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication