The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Instruments v / [TG] [TG11] Speed sensor problems at low speed with i70s and DST800

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] [TG11] Speed sensor problems at low speed with i70s and DST800
05-28-20, 10:55 AM (This post was last modified: 06-02-20 02:08 AM by Tom - Raymarine - Moderator.)
Post: #1
brownr377 Offline
Junior Member
**
 		Posts: 1
Joined: May 2020
Reputation: 0
[TG11] Speed sensor problems at low speed with i70s and DST800
Hey there, I've got a DST-800 triducer connected to an ITC-5, and an i70s display. At normal cruising speed 5-7 knots everything is fine speed is pretty accurate if speed through water drops to below about 1.5 or 2 knots the speed shown starts fluctuating wildly. Sometimes even tied to the dock the speed shows 100 kts!

I've been looking for some kind of a low speed filtering option or other and can't figure a way to calibrate this out, it's annoying cause it throws the log way off. Anybody got ideas? Is this a sensor issue, software issue, setting issue?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[TG11] Speed sensor problems at low speed with i70s and DST800 - brownr377 - 05-28-20 10:55 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication