The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Instruments v / [TG] [TG11] No sea temperature on MFD

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] [TG11] No sea temperature on MFD
06-03-20, 08:14 AM
Post: #1
jgol Offline
Junior Member
**
 		Posts: 6
Joined: Mar 2020
Reputation: 0
[TG11] No sea temperature on MFD
Recently I have installed system containing EV Wheel Autopilot and i70 system pack (speed/temp. , wind, depth). Connections/cables diagram is attached.
After turning power (at the dock) to instruments (back bone and ACU-100, 3 LED status lights inside iTC-5 (speed/temp, wind and depth) are constantly ON, SeaTalk light is ON. After few minutes, speed/temperature light starts flashing with the same intervals as 2 LEDs for Fluxgate compass and rudder (these 2 are not connected).
There is no SEA TEMPERATURE displayed on any menu on i70s display.
All transducer set ups were performed (speed, wind, depth). There as no option for temperature set up on Transducer set up menu.
DST800 is installed to read temperature, wired according to attached schematics.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[TG11] No sea temperature on MFD - jgol - 06-03-20 08:14 AM
RE: [TG11] No sea temperature on MFD - Tom - Raymarine - Moderator - 06-17-20, 12:23 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication