Threaded Mode | Linear Mode

Wdeertz · (This post was last modified: 06-19-20 01:41 AM by Tom - Raymarine - Moderator.)

I have a axiom pro with water temp data being provided by my sonar device. I just installed a yacht devices ydtc temperature probe to measure my engine room temperature. I configured the ydtc to output PGN 130311 with data type 3 (engine room temp). I can see the ydtc temp on the NMEA 2000 network but it’s not available on my axiom pro to insert as a page overlay. I followed up with yacht devices and they told me raymarine only supports water temp and air temp so my engine room probe will need to be configured as data type 1. I haven’t gotten to the boat to reconfigure but will assume this will work.

I’d like to add a yacht devices NMEA 2000 exhaust gas temp probe but if the raymarine can only support 2 temperatures I’m not sure if this is possible. Is it possible to have additional temperatures on the NMEA 2000 displayed on the axiom pro besides water and air temp?

If more temps can be displayed I could see adding refrigerator temp probes, live bait well, etc. surely raymarine shouldn’t limit to 2 temps.