The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Networking / System Integration v / SeaTalk to SeaTalk ng Conversion

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
SeaTalk to SeaTalk ng Conversion
06-06-20, 02:04 PM
Post: #1
Jonesy Offline
Junior Member
**
 		Posts: 1
Joined: Jun 2020
Reputation: 0
SeaTalk to SeaTalk ng Conversion
I recently acquired an older boat equipped with the following Raymarine products:

- Radome RD218
- DSM300
- Legacy E80 MFD
- RayStar 125
- Ray 215 VHF

The wiring is a mess so I am planning to upgrade to a SeaTalkng backbone. I have read every thread I can find that addresses this issue but am still unclear about the exact connection to the STNG converter. I have created the attached diagram which shows how I think the layout should look and highlights the 2 areas where I am uncertain.

Can you review the diagram and provide guidance? Any assistance is greatly appreciated.

Jones


Attached File(s)
.pdf  Raymarine wiring Conversion on YNOT.pdf (Size: 70.34 KB / Downloads: 639)
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
SeaTalk to SeaTalk ng Conversion - Jonesy - 06-06-20 02:04 PM

Forum Jump:


User(s) browsing this thread: 2 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication