[TG11] Integrating Axiom 7 with ST60+ Instruments

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[TG] [TG11] Integrating Axiom 7 with ST60+ Instruments

06-16-20, 02:34 AM

Post: #4

Tom - Raymarine - Moderator Offline

Administrator

Posts: 1,067
Joined: Nov 2017
Reputation: 7

RE: [TG11] Integrating Axiom 7 with ST60+ Instruments

Hello Hubert,

Most Seatalk instruments draw a tiny amount of current (an ST60+ display was typically around 35mA from memory) so unless you have large numbers of instruments or a very long cable run, I don't see any need for multiple power supplies and would avoid the extra complexity. The ST60+ Tridata installation manual for example says to use a single supply if you have less than 13 instruments on up to 10m of cable or up to 7 instruments on up to 20m of cable. I would just use the supply output from the T400G - unless your cable run is massive, that will be fine.

Regards,
Tom

Raymarine since 1999.
Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras
Location: Sydney, Australia.

Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests.

« Next Oldest | Next Newest »

Messages In This Thread

[TG11] Integrating Axiom 7 with ST60+ Instruments - phyc278 - 06-01-20, 09:40 PM

RE: [TG11] Integrating Axiom 7 with ST60+ Instruments - Tom - Raymarine - Moderator - 06-11-20, 01:10 AM

RE: [TG11] Integrating Axiom 7 with ST60+ Instruments - hubesail - 06-12-20, 03:06 PM

RE: [TG11] Integrating Axiom 7 with ST60+ Instruments - Tom - Raymarine - Moderator - 06-16-20 02:34 AM

RE: [TG11] Integrating Axiom 7 with ST60+ Instruments - hubesail - 06-16-20, 08:28 AM

RE: [TG11] Integrating Axiom 7 with ST60+ Instruments - Tom - Raymarine - Moderator - 06-16-20, 09:34 PM

User(s) browsing this thread: 1 Guest(s)