[CA11] Axiom unit keep rebooting after inserting NC2 lighthouse chart card

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[CA] [CA11] Axiom unit keep rebooting after inserting NC2 lighthouse chart card

06-19-20, 03:16 PM

Post: #8

cchildress44 Offline

Junior Member

Posts: 3
Joined: Nov 2019
Reputation: 0

RE: [CA11] Axiom unit keep rebooting after inserting NC2 lighthouse chart card

Chuck. I did as you said
Logged on the Flir book repair or service
Selected the Lighthouse Chart North America
Part#LHC-NAM-001
Website says - “is not configured for service in our system”
Called support to advise I was instructed to do this and they stated to reply on this forum for further instructions...
Please advise.

« Next Oldest | Next Newest »

Messages In This Thread

[CA11] Axiom unit keep rebooting after inserting NC2 lighthouse chart card - cchildress44 - 04-26-20, 07:43 AM

RE: [CA11] Axiom unit keep rebooting after inserting NC2 lighthouse chart card - Chuck - Raymarine - Moderator - 04-27-20, 10:36 AM

RE: [CA11] Axiom unit keep rebooting after inserting NC2 lighthouse chart card - captbob - 04-29-20, 07:22 PM

RE: [CA11] Axiom unit keep rebooting after inserting NC2 lighthouse chart card - Chuck - Raymarine - Moderator - 04-30-20, 08:15 AM

RE: [CA11] Axiom unit keep rebooting after inserting NC2 lighthouse chart card - captbob - 05-09-20, 08:27 AM

RE: [CA11] Axiom unit keep rebooting after inserting NC2 lighthouse chart card - Derek - Raymarine - Moderator - 05-11-20, 11:12 AM

RE: [CA11] Axiom unit keep rebooting after inserting NC2 lighthouse chart card - captbob - 05-11-20, 04:55 PM

RE: [CA11] Axiom unit keep rebooting after inserting NC2 lighthouse chart card - cchildress44 - 06-19-20 03:16 PM

RE: [CA11] Axiom unit keep rebooting after inserting NC2 lighthouse chart card - Chris - Raymarine - Moderator - 06-22-20, 02:12 PM

User(s) browsing this thread: 1 Guest(s)