Raymarine forum / Raymarine Forums / Autopilots v / ST6001+ NMEA and HSB2 SeaTalk interface

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
ST6001+ NMEA and HSB2 SeaTalk interface
07-05-16, 03:47 PM
Post: #2
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: ST6001+ NMEA and HSB2 SeaTalk interface
Welcome to the Raymarine Forum Greg,

Q1. Can I configure the RL80C+ as a backup source to drive the ST6000+? Can I leave the SeaTalk cable in place or do I need to isolate the two sources of autopilot data (PC and RL80C+) with a selector switch?
A1. There should be no need for any switches as you have suggested. The NMEA 0183 output of the PC may be interfaced to the course computer's NMEA 0183 input port, to the NMEA 0183 input port of the autopilot control head, or to the NMEA 0183 input port of the RL80C+ display. Navigation may be commanded from either the PC or RL80C+, but may only be stopped/cancelled by the device which had commanded navigation.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: ST6001+ NMEA and HSB2 SeaTalk interface - Chuck - Raymarine - Moderator - 07-05-16 03:47 PM

Forum Jump:


User(s) browsing this thread: 5 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication