The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error





Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
e Series Data Source Selection using E22158 Seatalk Converter
03-01-16, 03:33 PM
Post: #1
e Series Data Source Selection using E22158 Seatalk Converter
This post is a continuation of the post I started on the old forum at this link where I reported that the e97 and e125 MFD operating with Lighthouse V15 software would not allow manual selection of a data source on the Seatalk NG/ NMEA 2000 bus.

It turns out that the converter needed a software update to version 2.01. I was unable to get the MFD to recognize that the converter needed a software update and was unable to manually push it. I returned the converter to Raymarine and it was updated to the latest V2.01 software at no charge.

I am happy to report that this fixed the MDS problem and can now select the electronic compass I desire to use, rather than the compass on the S1G autopilot. Here is my system interconnection diagram for those interested. The system successfully integrates Raymarine, Nexus, Garmin, B&G and Standard Horizon products.

Bill Kneller
Vento Solare, J/109 #266
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
e Series Data Source Selection using E22158 Seatalk Converter - Bill Kneller - 03-01-16 03:33 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)