The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error





Thread Closed 
 
Thread Rating:
  • 1 Vote(s) - 1 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Weather application not populating - a/c/e/eS/gS-Series MFDs
01-06-16, 05:36 PM (This post was last modified: 01-10-17 03:02 PM by Chuck - Raymarine - Moderator.)
Post: #1
Weather application not populating - a/c/e/eS/gS-Series MFDs
Weather application not populating - a/c/e/eS/gS-Series MFDs

The following troubleshooting steps should be taken when the Weather application is not populating:
1. Verify that all electronics are powered ON
2. Verify that SiriusXM Satellite Weather Receiver's Status LED is illuminated and green in color - if not, refer to the section of your SiriusXM Satellite Weather Receiver's installation guide addressing the Status LED
3. Verify that the SRA-40/SRA-50 SiriusXM Antenna has an unobstructed view of the skies overhead
4. Verify that the SiriusXM Satellite Weather/Radio Receiver has been updated with the latest software (HOME->SET-UP->MAINTENANCE->DIAGNOSTICS->SELECT DEVICE->SR150/SR100/SR6/SR50; examine SDR/NDR Software Version and Patches data items)
5. Verify that the MFD's Weather Receiver Type (HOME->SET-UP->SYSTEM SETTINGS->EXTERNAL DEVICES->WEATHER SET-UP->RECEIVER TYPE) has been configured to match the model of SiriusXM Satellite Weather/Radio Receiver which has been interfaced to your system
6. Verify that the MFD senses that is has been interfaced to your SiriusXM Satellite Weather/Radio Receiver (HOME->SET-UP->MAINTENANCE->DIAGNOSTICS->SELECT DEVICE)
7. Verify that the connection/signal strength indicator within the Weather application's titlebar is specifying Medium or High signal strength. Low signal strength may indicate poor antenna location of a failure within the antenna, its cable, or the receiver itself. This is usually fault isolated by testing the receiver with a new antenna and cable.
8. Verify that the NOWRAD weather graphics layer (MENU->DISPLAY GRAPHICS->NOWRAD) has been configured to SHOW
9. Verify that the Radio Activation Status data item of the SiriusXM Weather Receiver's diagnostics (HOME->SET-UP->MAINTENANCE->DIAGNOSTICS->SELECT DEVICE->SR150/SR100/SR6/SR50) is reporting 1 0f -1 (1 07 0 for SR100). If not, it would indicate that the subscription has elapsed (contact SiriusXM) and/or that the receiver requires a restoration signal
10. Verify whether the Sirius Satellite Weather/Radio receiver requires a Restoration Signal (see related discussion addressing this subject)

RAYFAQ#
Find all posts by this user
Thread Closed 


Messages In This Thread
Weather application not populating - a/c/e/eS/gS-Series MFDs - Chuck - Raymarine - Moderator - 01-06-16 05:36 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)