ST1000+/ST600R troubleshooting

[wesdjohn]

There is no GPS sensor in the system. I thought the remote would display heading as fed from the tiller pilot #4 pin (yellow). I assume this is an electronic compass in the ST1000? (maybe I am mistaken, but I thought it did that several years ago)? I was doing this testing while stationary on the mooring.

So, maybe it is working as expected.....how could I get the remote to display heading - would I have to run the ST1000+ through my instruments first and then back to the remote 3-pin plug?

If I wanted to hook up the ST1000+ to my SeatalkNG backbone, how would I do this? I have a new i60 and i70 system daisychained with the wind/depth/speed going through the itc-5.

It looks like for wind data, I bypass the itc-5 and run the wind data via a cable extension to the 6-pin plug, correct?

Thanks for your help,
Wes J.