Troubleshooting 5s analog radar scanner

[Mark - Raymarine - Moderator]

Hello Miked,
Just so you are aware Raymarine no longer supports or repairs analog radar.
That being said you have an E-Classic MFD running the latest software, so if the end result is your radar is defective, the good news is you can upgrade to any current wired Raymarine Digital or HD Radar.
To trouble shoot:
If the scanner does count down to standby and then allows you to transmit, please make your active page a radar page, then set your range to 3nm.
After that press: Menu--->System Diagnostics--->External Interfaces--->Scanners Along the bottom of the page of the soft keys it will state "Self Test Result" press that soft key and look for anything that states "failed" or "Not Tested".
Then after that, perform the same button presses, along the bottom of the page of the soft keys it will state "Operation" press that soft key and then press "Radar Debug On" and look for the details that are listed in the upper left hand corner of the screen. Also in denoting these values, please make sure that the CT and FT values are not oscillating, only the SS value should be oscillating. If the CT and or the FT values are oscillating, the issue is within the radar core.
The SS value should typically be 100 +/- 20% at lower ranges and 130 +/- 20% at higher ranges. If the SS value is low or 0, then again the issue is in the radar core.
If there is a cable test fail, please use the following:
To check the cable you would disconnect the radar cable from the back of the display and measure the ohms resistance according to the information attached to this thread. If you see an open or some way off reading then go to the scanner at check directly on the radar pins for the same readings. If you get the reading, then you have a bad cable, if you still don't get the readings then the scanner is at fault. I have attached the radar cable test to this thread.