ST60+ with C120/80 Classic MFD adding DSM250

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

ST60+ with C120/80 Classic MFD adding DSM250

12-13-16, 01:14 AM (This post was last modified: 12-13-16 10:46 AM by Chuck - Raymarine - Moderator.)

Post: #3

tbharty Offline

Junior Member

Posts: 3
Joined: Jun 2016
Reputation: 0

RE: ST60+ with C120/80 Classic MFD adding DSM250

Chuck, what if with my existing transducer D800/p17, E26030 i wire the 3 wire to an airmare 7 pin connector/wire 7F-RR wire diagram 91-427

Airmar states transducer E66015 is compatible, so basically i can use my E26030 to simulate the E66015 by wiring 3 wires with 7 pin according to the diagram. Basically the E66015 already does this...i just don't want to have to change transducers

Airmar 7f-RR connector would plug into the DSM250 transducer slot in the back of the unit.

what do you think?

tom

« Next Oldest | Next Newest »

Messages In This Thread

ST60+ with C120/80 Classic MFD adding DSM250 - tbharty - 12-12-16, 01:00 AM

RE: ST60+ with C120/80 Classic MFD adding DSM250 - Chuck - Raymarine - Moderator - 12-12-16, 04:06 PM

RE: ST60+ with C120/80 Classic MFD adding DSM250 - tbharty - 12-13-16 01:14 AM

RE: ST60+ with C120/80 Classic MFD adding DSM250 - Chuck - Raymarine - Moderator - 12-13-16, 10:56 AM

RE: ST60+ with C120/80 Classic MFD adding DSM250 - tbharty - 12-13-16, 11:58 AM

RE: ST60+ with C120/80 Classic MFD adding DSM250 - Chuck - Raymarine - Moderator - 12-13-16, 02:14 PM

User(s) browsing this thread: 2 Guest(s)