The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Instruments v / wind transducer setup

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
wind transducer setup
01-09-17, 01:47 PM
Post: #1
charlie98117 Offline
Junior Member
**
 		Posts: 17
Joined: May 2016
Reputation: 0
wind transducer setup
I just installed a wind transducer with a wind pod to talk to my Seatalk NG system. I have a system with an i70 and an a78 MFD. When I first set it up I went to the transducer setup menu and it found the device and wanted me to go through a setup process out on the water. That was not convenient at the time but when I went back to do that process later the device is not found when the transducer setup looks for it. If I look on the Data menu I see the source for Wind is listed as Wind Pod. Lights are blinking on the Wind Pod so it seems to be getting signal. How can I get the setup program to find the wind transducer again?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
wind transducer setup - charlie98117 - 01-09-17 01:47 PM
wind transducer setup - Marcmmm - 12-04-17, 10:56 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication