Raymarine forum / Raymarine Forums / Product and Feature Suggestions v / moving the cursor on an a78 MFD

Thread Closed 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
moving the cursor on an a78 MFD
03-15-16, 08:45 AM
Post: #2
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: moving the cursor on an a78 MFD
Welcome to the Raymarine Forum Neil,

It is recommended that you verify that the MFD is receiving a GPS position FIX and has been centered on the vessel's location via the Chart application's Find Ship feature. If so, then touching any location on the screen should then cause the Chart application's cursor to move to the specified location and momentarily report range and bearing from the vessels position to the cursor's location. Holding one's finger pressed on the screen and then dragging it will cause the chart to be panned.
Find all posts by this user
Thread Closed 


Messages In This Thread
moving the cursor on an a78 MFD - Neilg - 03-12-16, 09:10 PM
RE: moving the cursor on an a78 MFD - Chuck - Raymarine - Moderator - 03-15-16 08:45 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication