Rudder Alignment Test - Dockside Wizard

[Chuck - Raymarine - Moderator]

Welcome the Raymarine Forum mlpayne9367,

If when centered, the reported rudder angle value is more than seven degrees, then the screws securing the rudder reference transducer should be removed, the transducer's base should then be rotated in a direction which will permit the reported rudder angle to be within seven degrees of the correct value, and then the transducer's screws may be installed to secure the transducer. Small amounts of rudder angle error may be removed via the Rudder Offset configuration setting (MENU->SET-UP->AUTOPILOT CALIBRATION->DRIVE SETTINGS->RUDDER OFFSET).