Raymarine forum / Raymarine Forums / Networking / System Integration v / SeaTalk to SeaTalkng converter setup

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
SeaTalk to SeaTalkng converter setup
02-03-17, 06:04 PM
Post: #9
Petersailor
Unregistered
 		 
RE: SeaTalk to SeaTalkng converter setup
If I disconnect the cable between the 3-way ST block to the ST6002 and instead connect the ST (yellow) cable from the second STng converter direct to the SeaTalk connection ob the ST6002, and then connect the two STng converters together with a Backbone cable.
I believe I then could remove the complete 3-way ST bock?
Is this correct understood?
Quote this message in a reply
Post Reply 


Messages In This Thread
SeaTalk to SeaTalkng converter setup - Petersailor - 02-01-17, 03:55 PM
RE: SeaTalk to SeaTalkng converter setup - Petersailor - 02-02-17, 04:02 PM
RE: SeaTalk to SeaTalkng converter setup - Petersailor - 02-02-17, 04:26 PM
RE: SeaTalk to SeaTalkng converter setup - Petersailor - 02-03-17, 03:50 PM
RE: SeaTalk to SeaTalkng converter setup - Petersailor - 02-03-17, 05:52 PM
RE: SeaTalk to SeaTalkng converter setup - Petersailor - 02-03-17 06:04 PM
RE: SeaTalk to SeaTalkng converter setup - Petersailor - 02-06-17, 04:20 PM
RE: SeaTalk to SeaTalkng converter setup - Petersailor - 02-07-17, 03:53 PM
RE: SeaTalk to SeaTalkng converter setup - Petersailor - 02-08-17, 02:02 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication